My 150cc scooters is Not Charging
Make sure the fuse in scooter is good.
Check the 150cc scooter wires behind the fuse holder and the charging jack. Sometimes they come loose.
My 150cc moped is Hard to Start?
Is the 150cc mopeds spark plug dirty? Clean or replace it if its dirty Make sure the 150cc mopeds carburetor and the intake manifold are tightly secured to the 150cc gas scooter engine.
Check the 150cc gas scooters gasket between the 150cc gas moped carburetor and 150cc gas mopeds intake manifold. Sometimes the 150cc scooter for sale gasket is bad and caused leak. Solution: replace new 150cc scooters for sale gasket or just toss the bad 150cc moped for sale gasket away and screw carburetor back. Try to start again.
My 150cc mopeds for sale Bogs out When I Turn the Throttle ?
Adjust the screw with the spring on the side of the 150cc chinese scooter carburetor. 150cc chinese scooters Clockwise to reduce gas flow and 150cc chinese moped counterclockwise to allow more gas follow. Usually bogged down is caused too much gas going thru the 150cc chinese mopeds carburetor.
Give time for it to warm up.
If that does not solve the problem, you need a new 150cc cheap scooter carburetor.
My 150cc cheap scooters is Leaking Oil From the 150cc cheap moped Carburetor & Muffler Areas
Check the gasket between the 150cc cheap mopeds carburetor and intake manifold. It might be bad or maybe the 150cc motor bike carburetor came loose due to 150cc motor bikes engine vibration.
My 150cc gas motor bike Electric Start Wont Work?
Make sure the squeeze the 150cc gas motor bikes left handle brake while pressing the 150cc motor bike for sale electric button.
When the 150cc motor bikes for sale electric start make clicking noise, it means your 150cc chinese motor bike battery is weak
Check the 150cc chinese motor bikes fuse.
Is your 150cc cheap motor bike key switch good?
Is the 150cc cheap motor bikes electric start giving out a burnt smell? You might have a burnt out electric start. Sometimes there is no smell.
My Engine Froze
The cause is lack of oil getting to the piston and needle bearing areas. Certain oil cant cling on when the engine get too hot. As a result, the needle bearing fell apart inside and caused the engine to cease. You can buy a new a engine or try to rebuild it? Be sure to always maintain proper engine oil levels to help prevent this from happening.
How Do I Adjust My scooters Brakes?
Brakes can be tightened by the handbrake area by the handlebar or by the wheel area.
My Scooter is Not Holding Its Charge?
Using the headlight, electric start and alarm (if applicable) too much will drain the battery.
Gas scooter does have the ability to charge itself but slowly. An optional charger can be for $25 at any local automotive stores.
Most new scooters would have a full charge and it would be display on the battery gauge. But in time, the batteries would loose their ability to hold a full charge. That’s normal!
Sometimes charging the batteries too much even when they are not low. Most of these batteries charging cycle are around 250-300 times.
Sometimes store your scooter away for a long period would cause that as well. If the battery power drops beyond a certain point, the charger would not recognize it. Sometimes you could jump start the batteries by using a higher Amp charger.
My scooters Has Problem When Running at High Speed
If the scooter idles well and runs fine at low speed, but has problems at high speed, the problem may lie inside the carburetor with the main jet. The fuel/air ratio at higher speeds is set by the jets inside the carburetor and to get at them the carburetor has to be removed and disassembled. This can be a tricky job as the parts are small and delicate. The good news is that these carburetors are quite cheap. You can get a new one for $60-$80, so if you can’t make your scooter run smoothly and you don’t like the idea of taking the carburetor apart, you can always replace it!