scooters Assembly
If you are located in CA, and you are picking up scooter from our moped retail store, you can choose to have your mopeds fully assembled and inspected by our trained gas scooter mechanics. If you order the gas scooters through our website, you’ll have some work to do. gas moped will arrive in a steel cage inside a cardboard box.
First remove the gas mopeds cardboard box. This is the easy part! Then you’ll need to take apart the scooter for sale steel cage by removing all the scooters for sale nuts and bolts holding it together. At some point in the process you may need a second person to help you by holding the moped for sale upright while you remove the last few mopeds for sale bolts and possibly the chinese scooter bailing wire used to secure the chinese scooters to the base of the cage. Most of the chinese moped we carry already have both wheels attached, you can roll it out of the case and set it on the center stand.
Now you can look for “chinese mopeds assembly instructions”, which with the average cheap scooter will be one sheet of paper which says something like “attach the rear view mirrors, install the cheap scooters battery, etc.”. You may have to use some ingenuity to figure out how to do all this, but it shouldn’t be beyond the capabilities of any amateur home mechanic. It may help if you have a decent socket set, screwdriver set and set of metric wrenches since the supplied “tool kit” usually leaves much to be desired.
cheap moped Batteries are typically shipped “dry” with the acid in a cheap mopeds separate container. You have to add the acid to the motor bike battery and leave it for 30 minutes of so before using it. After this it shouldn’t need to be charged to start the motor bikes.
Once you have all the gas motor bike parts attached (and that will include at least mirrors, seat, rear carrier, battery and floor mats), and you’ve waited about 30 minutes after adding acid to the battery, you’ll be ready to start the scooter.
If you just put fuel in the gas motor bikes tank, you may have to crank it quite a few times before it starts since the fuel has to get to the motor bike for sale carburetor and fill the float chamber before gas gets to the engine. You can prime the motor bikes for sale carburetor by disconnecting the fuel hose from the vacuum valve and connecting it directly to a small funnel and adding a little gas, then reconnecting the chinese motor bike fuel line to the valve and adding fuel to the tank. However if you don’t know what you’re doing, just try to follow whatever instruction came with the chinese motor bikes. Use premium gas. Most scooters seem to be setup to run on 91 octane fuel.
The final point of assembly is to check everything. Check the cheap motor bike tire pressures, check that every cheap motor bikes bolt and nut you can see is tight, especially the ones holding the exhaust and muffler – and the wheels! Look around for scooters lose wires or rubber hoses that don’t seem to be attached to anything.